Description

Raptor Adhesion Promoter Aerosol Clear is a convenient 450 ml primer designed to improve coating adhesion on difficult surfaces. It is particularly suitable for plastic and other substrates where additional adhesion is required before applying a protective coating.

What Raptor Adhesion Promoter Aerosol Clear is for

Its designed to improve coating adhesion on difficult automotive surfaces, including plastic, aluminium, galvanized metal, zinc, painted surfaces and fibreglass. For bare metal requiring corrosion protection, use Raptor Anti-Corrosive Epoxy Primer or Raptor Etch Primer as appropriate. After preparation, it can be overcoated with a suitable RAPTOR protective coating such as Raptor 1K Aerosol 450ml Black.

How to apply the Raptor Adhesion Promoter Aerosol

1. Clean and degrease the surface thoroughly, removing dirt, grease, wax and other contaminants.
2. Lightly abrade the surface where appropriate, then clean and allow it to dry completely.
3. Shake the aerosol thoroughly before use.

4. Apply a light, even coat of adhesion promoter, avoiding heavy application.

5. Allow the recommended flash-off time before applying the chosen topcoat.

Raptor Adhesion Promoter Aerosol Clear: key facts

• Adhesion promoter aerosol, 450 ml, clear
• Coverage: approximately 2.5–3 m² per can
• Flash-off time: 10 minutes
• Fully dry: 30 minutes
• Improves adhesion of subsequent coatings
• Suitable for plastic, aluminium, galvanized metal, zinc and fibreglass
• Ideal as a pre-treatment before applying protective coatings

Choose Raptor Adhesion Promoter Aerosol 450ml Clear for a convenient, ready-to-use adhesion promoter designed to improve coating adhesion on plastic and other difficult surfaces.

FAQ

What surfaces can it be used on?
It is suitable for surfaces such as plastic, aluminium, galvanized metal, zinc and fibreglass.
Does it replace a primer?
No. It is an adhesion-promoting pre-treatment and should be used according to the requirements of the surface and chosen topcoat.
Can it be used before coatings?
Yes. Once the adhesion promoter has been applied and allowed to flash off as recommended, a suitable Raptor coating can be applied.
How is it applied?
Clean and prepare the surface, shake the aerosol thoroughly, then apply a light, even coat before applying the topcoat.